0410515335 HOSE ASS’Y H.P. for Mitsubishi FB13TCB Forklifts

Overview

The 0410515335 HOSE ASS’Y H.P. | MLH4700, CS/RP is a high-pressure hydraulic hose assembly supplied for Mitsubishi electric counterbalance forklifts. It carries pressurised oil from the hydraulic pump to the lift circuit, allowing the mast to raise, lower and hold loads smoothly and predictably. A worn or leaking high-pressure hose typically shows up as slow lifting, visible oil loss or weeping fittings — and left unchecked, it can stop a truck entirely. Replacing it with the correctly specified 0410515335 for FB13TCB and its sister models is one of the simplest ways to protect uptime.

Compatibility

This Mitsubishi hose assembly is specified for two groups within the FB-series electric counterbalance range: the compact 1.3–1.8 tonne FB13–FB18 TCB/TBCB class and the 2.0–2.5 tonne FB20(H)CA and FB25(H)CA series. In practice, that means the same 0410515335 for FB13TCB also serves the neighbouring capacity points in the TCB/TBCB class, which simplifies parts planning for mixed fleets. If you are unsure about the fit, compare the number on your removed hose with 0410515335, or send us your truck model and serial number and we will confirm it for you.

Quality and Reliability

High-pressure hydraulic hoses work under constant stress: they flex with the mast, sit close to heat sources and must hold system pressure every working shift. This assembly is built to Mitsubishi’s original specification, with a reinforced high-pressure hose body and end fittings matched to the original routing, length and connection detail. That precision matters — a hose that is slightly out of spec can rub against the chassis, strain its fittings or restrict oil flow. Choosing the exact 0410515335 HOSE ASS’Y H.P. | MLH4700, CS/RP rather than a universal substitute keeps the hydraulic circuit performing the way the truck’s engineers intended.

Installation and Maintenance Tips

• Park on level ground, lower the mast fully, apply the park brake and disconnect the battery before working on these electric trucks.
• Relieve hydraulic pressure and capture the oil from the affected circuit, then cap open ports to keep dirt out of the system.
• Route the new hose exactly as the original, avoiding sharp bends and contact with the chassis, and reuse the original clips and brackets.
• Tighten the fittings to the torque values in the truck’s service manual and refill with the correct grade of hydraulic oil.
• After installation, cycle the mast slowly without a load, check both fittings for weeping, and re-inspect after the first working hours.
• As routine maintenance, look over the hose for abrasion, cracks, bulges or damp fittings, and replace it at the first sign of wear.

Why Order from Us

forkliftpartssearch.com specialises in forklift spare parts, so we know that a hose ordered today needs to be the hose that actually fits tomorrow. We list full compatibility information for every component, help you cross-reference part numbers, and our team is available to confirm the correct match before you order. If you run a mixed FB-series fleet and need several hoses, we can help you map each truck to the right part number.