0410515285 Hose Assy H.P. MLH4000 for Mitsubishi FB20(H)CA

Overview

The 0410515285 HOSE ASS’Y, H.P. MLH4000 is a Mitsubishi high-pressure hose assembly fitted to a defined range of FB-series electric counterbalance forklifts. High-pressure hoses sit at the heart of the hydraulic lift circuit, and heat, flexing and age gradually cause hardening, chafing or weeping fittings. Typical warning signs include slow mast response, visible oil loss along the hose run and oily residue around the chassis. Replacing a worn assembly with the correct numbered part restores full lifting performance and helps you avoid hydraulic contamination and unplanned downtime.

Compatibility

This hose assembly is catalogued for Mitsubishi electric counterbalance trucks in two series:

• FBTCB series – compact electric forklifts spanning the FB13TCB to FB18TBCB range, covering the 0410515285 for FB13TCB and its sister chassis
• FB(H)CA series – the FB20(H)CA and FB25(H)CA electric forklifts

One assembly serves this model family, so the same Mitsubishi 0410515285 applies whether you run the smaller FBTCB trucks or the FB(H)CA models. Hose routings can vary with mast type or production date, so always match the number 0410515285 against the parts manual entry for your truck’s model and serial number before ordering.

Quality and Reliability

Because this assembly is identified by the Mitsubishi part number 0410515285, it follows the original engineering specification rather than a generic close-match adaptation. In a high-pressure circuit, length, end fittings and pressure rating must all agree with the system they serve, and the MLH4000 assembly is specified for exactly that duty. A degraded hose can also restrict performance from the inside long before it leaks externally, so proactive replacement keeps lift speed and reliability where your operators expect them.

Installation and Maintenance Tips

• Fully lower the forks and mast, then relieve hydraulic pressure and isolate the truck before loosening any fitting.
• Place a container under the connection to catch oil, and cap open ports to keep contamination out.
• Route the new hose exactly as the original, reusing clips and guards so it cannot rub on the frame or mast channels.
• Inspect mating fittings and seals while the circuit is open, and replace anything scored or damaged.
• After refilling, cycle the lift slowly, check both ends for leaks and top up the reservoir as required.
• During routine service, examine all H.P. hoses for abrasion, bulges and weeping connections.

Why Order from Us

forkliftpartssearch.com specializes in Mitsubishi forklift spare parts, with catalog data for the 0410515285 HOSE ASS’Y, H.P. MLH4000 matched to the model applications listed above. If you are unsure this hose suits your truck, send us the model and serial number from the nameplate and our team will confirm fitment before your order is processed. From hydraulic hoses to filters, seals and drive components, we help keep Mitsubishi FB-series forklifts working productively.