Toyota 67830-13480-71 SENSOR ASSY, LEVER for 8FBN Forklifts

Overview

The 67830-13480-71 SENSOR ASSY, LEVER is a direct-fit replacement lever sensor assembly for Toyota electric forklifts. Mounted at the control lever, this sensor assembly reports lever position to the truck’s control system, so hydraulic functions respond smoothly and safety interlocks work as intended. When a lever sensor wears out, operators may notice erratic or unresponsive hydraulic levers, intermittent fault codes, or a truck that will not operate until the lever is cycled. Replacing the failed assembly with the correct part number restores dependable lever feedback and helps keep your 8-series electric truck productive.

Compatibility

The 67830-13480-71 for 50-8FBN15 and related trucks fits Toyota 8-series electric counterbalance forklifts in two model families:

• 50-8FBN series – compact electric cushion-tire models, including the 50-8FBN15
• 8FBN series – the standard 8FBN electric range, from the 8FBN15 up through the 8FBN25

These electric trucks are widely used in warehouses, distribution centers and light manufacturing, where smooth lever-controlled hydraulic operation matters on every shift. Trim levels and harness layouts can vary between trucks, so always verify the number on your existing sensor assembly, or cross-check your truck’s model and serial number against the Toyota parts manual, before ordering.

Quality and Reliability

This lever sensor assembly is built to match the original Toyota component’s fit, connector layout and signal output. Stable, consistent lever-position signals help reduce nuisance fault codes and keep hydraulic lever operation predictable throughout long warehouse shifts. Choosing the correct 67830-13480-71 replacement instead of an unverified substitute also helps protect related components, because inaccurate sensor output can affect how the control system interprets lever commands and interlock status.

Installation and Maintenance Tips

• Park on level ground, lower the forks fully and disconnect the battery before servicing electrical components.
• Follow the Toyota service manual for your specific model when removing panels and handling connectors.
• Compare the old assembly with the new sensor to confirm the connector and mounting points align.
• Keep contacts clean and dry; avoid spraying solvents or grease directly onto the sensor.
• After installation, cycle each lever, confirm proper hydraulic response and clear any stored fault codes.
• During routine service, inspect the lever harness for wear or chafing that can mimic sensor failure.

Why Order from Us

At forkliftpartssearch.com, we specialize in Toyota forklift parts and make it simple to find exact-fit components by part number. Our team can help you confirm that the 67830-13480-71 SENSOR ASSY, LEVER matches your truck before you order, and every listing clearly identifies the part so you can buy with confidence. Whether you maintain a single 8FBN truck or an entire electric fleet, we help you get the right part the first time and keep downtime to a minimum.