0009812281 Gear Pump for Linde E15/18B E20/25B Forklifts

Overview

The 0009812281 gear pump is a hydraulic gear pump specified for Linde electric counterbalance forklifts in the B-series range. The gear pump sits at the heart of the hydraulic system: it converts drive rotation into a steady flow of pressurized oil that powers lift, tilt and auxiliary functions. When a pump wears out, operators notice slower lifting, whining or growling noises, drifting masts and a general loss of hydraulic response. Fitting a new 0009812281 gear pump restores rated flow and pressure, bringing hydraulics back to the performance the truck was built for.

Compatibility

The 0009812281 for E15/18B is specified across the Linde B-series electric forklift family, so one replacement covers the full E15–E35 B-series range:

• E15/18B – compact 1.5–1.8 ton electric counterbalance trucks
• E20/25B – 2.0–2.5 ton mid-capacity models
• E30B / E35B – 3.0–3.5 ton heavy-duty B-series electric trucks

Because these B-series trucks share a common hydraulic layout, the same 0009812281 unit serves light and heavy models alike. Always confirm fitment against the data plate and the part number on your existing pump before ordering.

Quality and Reliability

This replacement gear pump is built to Linde OEM specification for mounting dimensions, tolerances, sealing surfaces and flow characteristics, so it drops into the truck’s hydraulic circuit without modification. Quality materials and precise machining keep internal clearances consistent under pressure, while the shaft seals resist hydraulic fluid and heat over long duty cycles. A healthy pump means stable lift speeds, smooth mast control and predictable hydraulic response – the day-to-day reliability that Linde electric forklifts are known for in warehouse and yard operation.

Installation and Maintenance Tips

• Verify the number 0009812281 on the data plate or on your existing pump before starting the job.
• Disconnect the battery, depressurize the hydraulic circuit and lower the mast fully before removing the old pump.
• Work clean: check the condition of the hydraulic oil, replace the filter and inspect the suction line for debris or collapse – contamination is the most common cause of premature gear pump failure.
• Fit new O-rings and seals at the flange and suction connection, and torque the mounting bolts evenly to the values in the Linde service manual.
• Bleed the system as described in the manual, then run the truck at low speed and check for leaks or unusual noise before returning it to full duty.

Why Order from Us

ForkliftPartsSearch.com specializes in Linde forklift parts, from wear items to hydraulic components like this gear pump. Our team helps you confirm the correct part for your truck, cross-checks serial and part numbers when fitment is unclear, and supports you from quote to delivery. With a broad Linde catalog in one place, you can order the 0009812281 gear pump alongside the filters, seals and electrical parts your fleet needs – and get your trucks back in service with minimal downtime.