Toyota 04653-30130-71 Lift Cylinder Overhaul Kit 3FD80 5FD70

Overview

The 04653-30130-71 CYLINDER O/H KIT, LIFT is a Toyota overhaul kit built to restore the lift cylinder on heavy-duty Toyota diesel forklifts. Lift cylinders operate under constant hydraulic pressure, and over time the internal seals and O-rings harden, wear and start to leak. The result is slow lifting, forks that drift down under load and reduced lift capacity. This overhaul kit supplies the sealing components needed to rebuild the lift cylinder, bringing lifting speed and load control back to specification without the cost of replacing the complete cylinder assembly.

Compatibility

Searching for the 04653-30130-71 for 3FD80? This kit covers two Toyota model families:

• 3FD / 3FDE series – 3FD80, 3FDE60, 3FDE70
• 5FD series – 5FD50, 5FD60 and 5FD70, including the 50-5FD60 and 50-5FD70 variants

If you are unsure whether this kit matches your truck, check the part number stamped on your existing cylinder, or send us your forklift model and serial number and our team will help you confirm fitment before you order.

Quality and Reliability

Because this is a Toyota part supplied under the exact number 04653-30130-71, the seal dimensions and materials are matched to the original lift cylinder design. That matters on hydraulic lift cylinders, where an incorrectly sized or low-grade seal can fail quickly under pressure and heat. Ordering by the full part number means you receive the same overhaul kit Toyota specifies for these trucks, helping your rebuilt cylinder hold pressure and perform consistently shift after shift.

Installation and Maintenance Tips

• Fully lower the forks and relieve all hydraulic pressure before disconnecting any lines.
• Support the mast and cylinder securely; a lift cylinder is heavy and awkward to handle.
• Cap or plug hydraulic lines immediately to keep dirt out of the system.
• Clean the cylinder bore and inspect the rod for scoring, pitting or corrosion. If the rod surface is damaged, resealing alone will not hold.
• Fit the new seals from the 04653-30130-71 kit carefully, avoiding cuts or nicks to the seal lips.
• Lubricate the seals with clean hydraulic fluid, reassemble, bleed air from the circuit, then cycle the cylinder slowly and check for leaks.

Why Order from Us

Forkliftpartssearch.com specializes in forklift replacement parts, from complete overhaul kits like the 04653-30130-71 CYLINDER O/H KIT, LIFT to individual hydraulic and wear components for Toyota and other major brands. Search by part number, confirm fitment for your specific model, and get clear answers from a team that knows forklift hydraulics. Order your 04653-30130-71 lift cylinder overhaul kit today and keep your 3FD or 5FD truck lifting safely and efficiently.