50451632 Hose, Hydraulic for Jungheinrich DFG Forklifts

Overview

The 50451632 Hose, Hydraulic is a replacement hydraulic hose manufactured to match the original specification for Jungheinrich diesel counterbalance forklifts. Hydraulic hoses carry pressurized oil between the pump, control valve, lift cylinders and tilt cylinders, so a chafed, bulging or leaking hose has a direct impact on lifting performance and site safety. If your truck shows fluid weeping at the fittings, a cracked or blistered hose cover, or a mast that creeps down under load, fitting the 50451632 for DFG applications is a reliable way to restore full hydraulic function.

Compatibility

This hydraulic hose is specified for the following Jungheinrich truck series:

• DFG 60/70 DK series — diesel counterbalance trucks from serial number 5250 onward (Ser.Nr. 5250>>>)
• DFG 660-4 series — including the cylinder (cyl.) configuration

Always confirm your truck’s model designation and serial number on the chassis data plate before ordering, and compare the length, bend angles and end fittings of your existing hose with the product images. If you are unsure whether the 50451632 for DFG is the right match, send us your serial number and our parts specialists will verify the fitment for you.

Quality and Reliability

Jungheinrich hydraulic circuits operate at high working pressures, so hose specification matters. The 50451632 Hose, Hydraulic is supplied to match the original design — correct hose type and reinforcement, working pressure, length and end connections. Consistent manufacturing tolerances mean the hose seats properly on its fittings and follows the intended routing, which helps prevent leaks, vibration wear and premature failure in demanding daily duty cycles.

Installation and Maintenance Tips

• Relieve the hydraulic system pressure and fully lower the mast before disconnecting any line.
• Place trays under the work area and plug open ports to keep dirt out of the circuit.
• Route the new hose exactly as the original, clear of sharp edges and hot surfaces, and refit all clips and brackets.
• Tighten the fittings to specification, then run the truck at idle and check every joint for leaks before returning it to service.
• Inspect hydraulic hoses at each service interval for abrasion, cracks, damaged fittings and soft spots, and replace any hose that shows wear.

Why Order from Us

forkliftpartssearch.com supplies Jungheinrich spare parts to forklift fleets, service workshops and equipment dealers. Every listing is checked against the manufacturer’s parts data, and our team is available to confirm fitment using your model and serial number before you commit to the order. When you need the 50451632 Hose, Hydraulic for a Jungheinrich DFG truck, you get accurate part identification, straightforward ordering and dependable support from a specialist supplier.