Jungheinrich 50101141 Hydraulic Pump for EDB, EDC & EDH

Overview

The 50101141 Pump, Hydraulic is a replacement hydraulic pump for Jungheinrich material handling equipment, supplied by forkliftpartssearch.com. The hydraulic pump is the heart of the lift circuit: it converts drive power into oil flow and pressure that raise the forks or lift platform. When a pump wears out, symptoms such as slow lifting, a drifting mast, unusual noise or visible oil loss usually appear first. Fitting a new 50101141 Pump, Hydraulic restores proper lift speed and load control and helps protect the rest of the hydraulic system from strain caused by a worn or leaking pump.

Compatibility

This hydraulic pump is used across several Jungheinrich series. The 50101141 for EDB machines and the related models below share the same pump reference:

• EDB 20+32 series
• EDC 20 G series
• EDH 75-100 series
• EDK

Before ordering, compare the number stamped on your existing pump or listed in the Jungheinrich parts manual with 50101141. If you cannot locate the reference, send us your model and serial number and our parts team will confirm the correct pump for your truck.

Quality and Reliability

Hydraulic pumps operate at high pressure, so internal clearances and surface finishes matter. This replacement pump is produced to match the original Jungheinrich specification for mounting points, drive interface, port sizes and operating pressure, so it installs in place of the worn unit without modification. Each pump is supplied ready to fit, and we recommend replacing the hydraulic oil and filtration at the same time to keep contaminants out of the new pump. Ordering a pump matched to the exact Jungheinrich part number reduces the risk of returns, rework and unplanned downtime.

Installation and Maintenance Tips

• Depressurize the hydraulic system and lower the forks or platform fully before starting work.
• Disconnect the battery on electric models such as the EDB and EDC series before removing components.
• Drain the oil tank and inspect the old oil for metal particles, which can indicate internal pump damage.
• Replace the suction strainer or filter and refill with clean hydraulic oil of the grade specified by Jungheinrich.
• Renew the O-rings and seals at the pump ports, tighten the fasteners evenly to the specified torque, and prime the pump before start-up.
• After the first lift cycles, check the fittings and pump body for leaks and top up the oil level as needed.

Why Order from Us

forkliftpartssearch.com specializes in spare parts for forklifts and warehouse equipment, including Jungheinrich models. When you order the 50101141 Pump, Hydraulic from us you benefit from:

• Accurate part identification based on part number, model and serial number
• Clear product information so you can verify fitment before you buy
• Support from a team that works with forklift parts every day
• Simple online ordering for the 50101141 for EDB, EDC, EDH and EDK applications

Keep your Jungheinrich equipment lifting reliably — order part number 50101141 today.