04112-40150-71 Toyota Engine Valve Grind Gasket Kit 2TD15

Overview

The 04112-40150-71 GASKET KIT, ENGINE VALVE GRIND is a Toyota gasket set intended for top-end engine work on Toyota forklifts. When a cylinder head is removed for valve grinding, lapping or a general de-coke, the gaskets that seal the head, valve cover and associated passageways are disturbed and must be renewed before reassembly. This kit supplies those replacement gaskets under a single Toyota part number, so the job can be completed without hunting for individual seals. It is the part referenced as 04112-40150-71 for 02-2TD15 and the other compatible trucks listed below.

Compatibility

This valve grind gasket kit covers a defined group of Toyota forklifts:

• 02-2TD series – 02-2TD15 through 02-2TD25
• 02-2TG series – 02-2TG20 and 02-2TG25
• 2TD20 trucks

Engine and head configurations can vary within a model range, so we recommend confirming fitment against your truck’s serial number and parts book before ordering. If you send us your chassis or engine number, our team will check the application for you.

Quality and Reliability

Valve grind gaskets operate in the harshest part of the engine, where combustion heat, cylinder pressure and thermal cycling place constant demands on every seal. Because this kit is supplied under the Toyota part number 04112-40150-71, it is produced to Toyota’s material and dimensional specification, giving a precise fit on the mating surfaces and dependable sealing once the head is torqued down. A fresh gasket set helps restore compression, keeps oil and coolant where they belong, and protects the overhaul work you have just carried out.

Installation and Maintenance Tips

• Clean all mating surfaces thoroughly and remove old gasket material and carbon without scoring the head or block face.
• While the head is off, check it for flatness, cracks and worn valve guides — a valve grind is the ideal moment to catch underlying faults.
• Fit the new gaskets dry or with only the sealant Toyota specifies for your engine.
• Tighten the head bolts in the published sequence and stages with a calibrated torque wrench; do not guess at torque values.
• Recheck head bolt torque after the initial run-in period and watch for oil or coolant weeping during the first hours of operation.
• Keep the replaced gaskets until the overhaul is proven, so any issue can be diagnosed quickly.

Why Order from Us

forkliftpartssearch.com specialises in forklift parts rather than general automotive stock. That focus means accurate part identification, clear application data and a team that reads Toyota model codes such as 02-2TD20 and 02-2TG25 every day. If you are unsure whether the 04112-40150-71 GASKET KIT, ENGINE VALVE GRIND matches your engine, send us your model and serial number and we will confirm the correct part before you place the order.