0400512195 Mitsubishi Hose Ass’y H.P. for RBS20/25/30CB
Overview
The 0400512195 Hose ass’y, H.P. | 30(L)cb, wide type for triplex mast is a high-pressure hydraulic hose assembly for Mitsubishi electric counterbalance forklifts. It carries pressurized oil to the lift cylinders on trucks fitted with the wide-type triplex mast, where steady pressure is essential for smooth lifting, precise load control and reliable performance at full mast height. Because this line operates under continuous high pressure, a worn or damaged hose can quickly cause pressure loss, oil contamination and unplanned downtime. Fitting the correct 0400512195 assembly restores the hydraulic response your RBS-series truck was built for.
Compatibility
This Mitsubishi hose assembly is specified for the RBS-CB and RBS-CB1 series of electric counterbalance forklifts, covering the 2.0-ton RBS20CB, RBS20-CB1 and RBS20CB1, the 2.5-ton RBS25CB and RBS25-CB1, and the 3.0-ton RBS30CB. The “30(L)cb, wide type” designation in the part name identifies the wide-type triplex mast configuration, so confirm that your truck carries this mast variant before ordering. If you searched for “0400512195 for RBS20-CB1” or a similar model-specific phrase, this is the correct application listing. When in doubt, our team can verify fitment against your truck’s model and serial plate.
Quality and Reliability
High-pressure hose assemblies are among the most safety-critical wear items in a mast circuit. This replacement hose is produced to match the fit, form and function of the original Mitsubishi component, featuring properly crimped end fittings, reinforced construction rated for the triplex mast’s working pressure, and an abrasion-resistant outer cover suited to contact with mast channels and guides. Consistent manufacturing dimensions allow the hose to route like the factory part, avoiding sharp bends, stretch and chafing points that can shorten service life and lead to premature failure.
Installation and Maintenance Tips
Before starting, park the truck on level ground, lower the forks fully and relieve hydraulic pressure in the mast circuit. Wear eye protection and gloves, as residual pressure and hot oil can cause injury, and place absorbent material beneath the work area. When swapping the old assembly, compare fitting orientation and bend direction with the new 0400512195 hose, secure it with the original clamps, and make sure it cannot contact sharp edges or moving mast parts. After refilling and bleeding the system, cycle the mast slowly and inspect every connection for leaks. Check all high-pressure hoses at regular service intervals for abrasion, bulging and weeping fittings, and replace any suspect line immediately.
Why Order from Us
Forkliftpartssearch.com focuses on forklift spare parts, so our listings are built around accurate part numbers and real model applications rather than guesswork. Ordering the 0400512195 Hose ass’y, H.P. | 30(L)cb, wide type for triplex mast here means clear compatibility data, support from a team familiar with Mitsubishi RBS-series trucks, and assistance cross-referencing the number on your original hose if you are unsure. Order today and keep your triplex mast lifting smoothly.