Linde 0009641419 Hose 7/32″x100mm for H14-H18 Forklifts

Overview

The 0009641419 hose 7/32″x100mm is a Linde replacement hose specified for the manufacturer’s compact IC counterbalance forklifts. With a 7/32″ bore and a 100 mm finished length, it is engineered to match the original Linde specification, so it drops straight into the existing line routing without adapters or re-bending. If a cracked, chafed or weeping line is causing downtime on your H-series truck, this hose restores the connection to factory dimensions.

Compatibility

The 0009641419 hose is specified for the Linde H14, H16 and H18 series internal-combustion counterbalance trucks, covering diesel (D), LPG (T) and CNG fuel variants across the range. Whether you are fitting the 0009641419 for H14D yard duties, an H16T on LPG or an H18CNG in an emissions-sensitive facility, this is the reference to quote. Because Linde carried a consistent line specification through these series, one part number covers the full H14–H18 range. If you are unsure which hose your truck needs, send us the serial number or the marking on the original hose and we will confirm the match before you order.

Quality and Reliability

Hoses are only as good as their dimensional accuracy. This 0009641419 hose is produced to the original bore, length and fitting configuration, so clamps, unions and brackets sit exactly where Linde intended. That means correct routing, no stretched or kinked sections and a dependable seal from the first start-up. Supplying the part under its exact reference — 0009641419 — removes the guesswork from matching worn or unlabelled hoses on busy H-series fleets.

Installation and Maintenance Tips

• Depressurise and isolate the relevant circuit before disconnecting the old hose, and catch any residual fluid.
• Compare old and new: same 7/32″ bore, same 100 mm length, same fitting orientation.
• Route the hose exactly as the original, clear of sharp edges and hot surfaces, and avoid twisting it while tightening.
• Tighten fittings evenly and check for weeps after the first run.
• At every service, inspect short lines for abrasion, hardening, bulges or damp patches, and replace them before they fail.

Why Order from Us

forkliftpartssearch.com specialises in Linde forklift parts, identified quickly and accurately by part number. When you order the 0009641419 hose 7/32″x100mm you benefit from:

• Fast identification through our extensive Linde reference data
• Support verifying fitment against your truck model and serial number
• One source for H14–H18 wear parts, filters and line components

Keep your Linde H-series fleet moving — add the 0009641419 hose to your order today.