Linde 0009552051 Hose Clip B1-10×9-W1-2 | H12-H20 Forklifts

Overview

The 0009552051 hose clip B1-10×9-W1-2 is a compact metal hose clamp specified by Linde for its internal combustion counterbalance forklifts. Its job is small but critical: holding narrow-diameter hoses and lines firmly on their fittings so they cannot slip, chafe or weep fluid under vibration and pressure cycles.

A worn, corroded or over-tightened clip is one of the most common causes of small leaks and unplanned downtime. Swapping it for a correct-fit replacement is quick, inexpensive and well within the scope of any workshop or maintenance team.

Compatibility

The 0009552051 is listed as compatible with the following Linde truck ranges:

• H12 series – H12D, H12T
• H16 series – H16D, H16T
• H18 series – H18D, H18T
• H20 series – H20D
• C4130 truck type

These trucks make up Linde’s compact internal combustion counterbalance range in the 1.2–2.0 tonne class, available with diesel (D) and LPG (T) drivelines. No alternative OEM cross-reference numbers are published for this part. If the clip on your truck carries a different marking, send us the number along with your model and serial number and our parts specialists will verify the correct item before you order.

Quality and Reliability

Hose clips look interchangeable, but an undersized or soft substitute can distort, lose tension or cut into the hose. This clip is supplied to match the original Linde dimensions, band profile and clamping geometry, so it seats squarely on the hose, holds steady under engine vibration and releases cleanly for service. Ordering by the exact Linde reference number 0009552051 removes the guesswork and reduces the risk of returns or repeat repairs.

Installation and Maintenance Tips

• Release the old clip fully with a flat screwdriver or nut driver before sliding it back off the fitting.
• Fit the new clip behind the bead or flange of the connector, never on the very edge of the hose.
• Tighten until snug and then a fraction more — excessive torque cuts into rubber and shortens hose life.
• Always renew clips that show corrosion, a cracked band or a stripped screw; a clip this small is not worth reusing.
• During scheduled service, inspect accessible clips for seepage and re-tension where necessary.

Why Order from Us

forkliftpartssearch.com specialises in Linde forklift spare parts, from major driveline components down to clips, seals and fasteners like the 0009552051 for C4130, H12–H20 and related trucks. You get accurate fitment data, help identifying parts from your serial number, and advice from people who work with Linde trucks every day. Because clips like this cost little, it pays to keep a few in your spares cabinet — a two-minute hose re-clamp can save an entire shift.