Linde 0009442346 Line Break Safety Valve LBS-1,0/140

Overview

The 0009442346 line break safety valve LBS-1,0/140 is a hydraulic safety component fitted to a range of Linde forklift trucks. Mounted in the lifting circuit, it is designed to cut off uncontrolled oil flow if a hydraulic hose or line should fail, helping to hold a raised load in position rather than allowing it to descend suddenly. Because this valve is directly involved in load safety, a worn, contaminated or damaged unit should be replaced promptly with a part that matches the original Linde specification. This replacement is produced to the LBS-1,0/140 rating, so the valve’s protective function stays consistent with the hydraulic system your truck was built with.

Compatibility

The 0009442346 for E25S and the other listed applications covers several popular Linde truck families. To make checking easier, the fitment can be grouped by series:

• E-series electric counterbalance trucks, including E25S and E30S
• Larger E-series electric models E35P, E40P and E48P
• H-series internal combustion trucks H20D and H25D
• EX explosion-protected trucks

Always verify the valve against part number 0009442346 in your truck’s parts book or data plate before ordering. If you are unsure whether this LBS-1,0/140 valve suits your Linde model, our team can help you confirm the match.

Quality and Reliability

A line break valve only performs when its internal seat, spring and tolerances are precise. This replacement is manufactured to correspond with the original Linde design, so the valve opens and closes at the intended operating point and reacts quickly to a sudden loss of line pressure. Materials are selected for hydraulic service, supporting stable performance through regular forklift duty cycles. Choosing a specification-matched valve rather than a generic alternative helps preserve the engineered safety margin of your truck’s hydraulic system.

Installation and Maintenance Tips

• Fully lower the forks and relieve all hydraulic pressure before starting work.
• Disconnect the battery on E-series electric trucks and follow your site’s lockout procedure.
• Inspect nearby hoses, fittings and seals while the valve is accessible, and replace anything showing wear.
• Install the valve with clean fittings and tighten to the torque values given in the Linde service manual.
• After installation, carry out a lift test and check all connections for leaks.
• Include the line break valve in your scheduled hydraulic inspections.

Why Order from Us

forkliftpartssearch.com focuses on forklift spares, including a wide selection of Linde components. You get accurate, model-specific product information, support from a team that understands forklift hydraulics, and a straightforward ordering process for the 0009442346 line break safety valve LBS-1,0/140. Keep your Linde truck’s load-holding protection intact and order the correct valve with confidence.