50060570 Hydraulic Hose – Jungheinrich Forklift Spare Part

Overview

The 50060570 Hose, Hydraulic is a replacement hydraulic line designed for Jungheinrich forklifts. Hydraulic hoses carry pressurized fluid between the pump, control valve and lift cylinders, so a worn or leaking line directly affects lift performance, load holding and operator safety. If you notice weeping fittings, a bulging or soft cover, visible abrasion or hardened, cracked sections along the line, fitting a correct 50060570 hydraulic hose restores the original length, routing and connection style — no improvising with generic hose.

Compatibility

The 50060570 for 3205729/59003266 fits Jungheinrich trucks in the 3205 chassis series, a group that runs from 3205729/59003266 and 3205737/59003267 through mid-series trucks such as 3205750/59003526 and 3205778/59003610, up to 3205802/59003807. Each code pairs a chassis or material number with its associated serial number. Before ordering, check both figures on your truck’s data plate or in its service documentation. If you are not certain that the 50060570 Hose, Hydraulic matches your machine, send us your full truck data and we will verify the fit.

Quality and Reliability

Hydraulic lines work hard in forklift service: constant pressure cycles, flexing during lifting, heat and exposure to dust and moisture. This replacement hose is produced to match the fit, pressure rating and end fittings of the original Jungheinrich component, so it sits in the intended position without stretching or kinking. Sound reinforcement construction and clean, undamaged fittings help maintain a tight seal from the first installation, reducing the risk of fluid loss and unplanned downtime.

Installation and Maintenance Tips

• Park on level ground, fully lower the mast and forks, switch the truck off and depressurize the hydraulic circuit before loosening any fitting.
• Position a container under connection points to catch residual fluid, and keep hydraulic oil away from skin and ignition sources.
• Inspect the mating fittings and seats; replace any component that shows damage before reassembly.
• Route the new hose exactly as the original, clear of pinch points, hot surfaces and sharp edges, and secure it with the original clips.
• Tighten connections to the torque values in the Jungheinrich service manual and avoid overtightening.
• After installation, check for leaks at low pressure first, then run full lift cycles and re-inspect.
• As part of routine service, examine hoses for abrasion, cuts, soft spots and weeping fittings, and replace worn lines promptly.

Why Order from Us

forkliftpartssearch.com specializes in forklift spare parts, including Jungheinrich components identified by exact part number. When you order the 50060570 Hose, Hydraulic, you get a part matched to your truck plus support from people who understand forklift hydraulics. Need related hoses, seals or fittings? Send us your chassis and serial numbers and we will help you identify everything you need in one order.