50036584 Hydraulic Hose for Jungheinrich EFG-DH EFG-V

Overview

The 50036584 Hose, Hydraulic is a replacement hydraulic hose for Jungheinrich forklifts, covering the EFG-DH, EFG-V, EFG-VAC and FB model ranges. This hose transports pressurised hydraulic fluid between the pump, control valves and lift cylinders, making it a critical component of the truck’s lifting system.

Hydraulic hoses operate under constant pressure cycles, heat and vibration, and their lining and fittings wear over time. Cracks, bulges, abrasion or weeping fittings are clear warning signs. Replacing a worn hose with the correct 50036584 Hose, Hydraulic restores full lifting performance, prevents fluid loss and protects other hydraulic components from contamination and damage.

Compatibility

The 50036584 for EFG-DH and the other listed trucks fits the following Jungheinrich model series:

• EFG-DH 12.5/15B series
• EFG-V 20L-30 series
• EFG-VAC 25/30 series
• FB 10-15 series

Because Jungheinrich forklifts were produced in many configurations, we recommend verifying the part number 50036584 against your machine’s documentation or nameplate before ordering. If you are unsure, our team can help you match the hose to your specific model and serial number.

Quality and Reliability

This hydraulic hose is manufactured to match the original Jungheinrich specification for length, bore, pressure rating and end fittings, so it connects directly to the existing hydraulic lines without modification. A robust outer cover resists the abrasion and wear typical of busy warehouse and industrial environments, while the inner lining is designed to withstand the hydraulic fluid and pressure peaks found in forklift lifting circuits. A properly seated, leak-free hose keeps the hydraulic system clean and maintains consistent mast performance.

Installation and Maintenance Tips

• Fully lower the forks and mast, switch off the truck and release the pressure in the hydraulic system before starting work.
• Allow the system to cool and place a container under the connection points to catch residual fluid.
• Clean the area around the fittings so no dirt enters the open hydraulic circuit.
• Route the new hose exactly as the original, away from hot surfaces, sharp edges and moving parts.
• Tighten the fittings to the correct torque — overtightening can damage the sealing surfaces.
• After installation, run the lifting cycle and check all connections for leaks, then top up the hydraulic fluid as needed.
• Inspect the hose regularly as part of routine service and replace it at the first sign of wear.

Why Order from Us

forliftppartssearch.com specialises in forklift spare parts, with a wide selection of Jungheinrich components for EFG and FB trucks. When you order the 50036584 Hose, Hydraulic, you benefit from accurate part-number matching, knowledgeable support before and after purchase, and straightforward ordering. Need help confirming compatibility? Send us your forklift’s model and serial number and we will make sure you get the right hose for your truck.