Mitsubishi 3561035950 Push Switch Assembly FB10-FB18 Series

Overview

The 3561035950 PUSH SWITCH ASSEMBLY is a Mitsubishi-brand replacement switch used in the operator control panel of Mitsubishi electric counterbalance forklifts. When a push switch becomes worn, unresponsive or intermittent, it can disrupt daily operations and make the truck inconvenient or unsafe to use. Fitting a new 3561035950 PUSH SWITCH ASSEMBLY restores dependable push-button control so your operators can get back to work quickly.

Compatibility

The 3561035950 for FB10(H)CA1(J) trucks and the rest of its series is specified for the following Mitsubishi electric forklift families:

• FB10–FB18 CA1(J) series: FB10(H)CA1(J), FB14(H)CA1(J), FB15(H)CA1(J), FB18(H)CA1(J)
• FB10–FB18 CA series: FB10CA, FB14CA, FB15CA, FB18CA

These compact electric counterbalance trucks cover approximately the 1.0 to 1.8 tonne capacity range and are widely used in warehousing, distribution and light manufacturing. The same switch assembly applies across the group, including (H) variants and (J) suffix models. No separate OEM cross-reference numbers were supplied for this part; if your old switch carries an existing reference number, our parts specialists can confirm interchangeability before you order.

Quality and Reliability

This switch assembly is supplied as a Mitsubishi-branded replacement, produced to the specification of the original component fitted to the truck. That means correct connector orientation, matching mounting points and electrical ratings appropriate for the control circuit of these FB-series electric forklifts. Ordering the correct part number rather than a generic substitute helps you avoid wiring adaptations, intermittent faults and premature failure.

Installation and Maintenance Tips

• Disconnect and isolate the battery before working on any electrical component.
• Compare the number 3561035950 on your old switch with the replacement before installation.
• Photograph the wiring layout before removing connectors to make reassembly straightforward.
• Inspect the harness and terminals for corrosion, wear or damage while the switch is removed.
• After fitting, test the switch through several full operating cycles before returning the truck to service.

Why Order from Us

At forkliftpartssearch.com we focus on supplying the right part, not just a part. When you order the 3561035950 PUSH SWITCH ASSEMBLY you benefit from accurate fitment data for the FB10–FB18 CA and CA1(J) series, support from experienced parts staff who can verify compatibility against your model and serial number, and clear, honest product information. Order today and keep your Mitsubishi electric forklifts moving.